HIMA F3331通讯模块
1.产 品 详 情 资 料：
检测到F（故障）/红色单元错误。由控制软件控制。在控制器复位期间由硬件进行设置和清除。R（un）/绿色运行。由控制软件控制。在控制器复位过程中被硬件清除。100MBit/s开启当Rx-Tx/黄色闪烁时，建立100 MBit/s的有效连接。100MBit/s关闭当Rx-Tx/黄色闪烁时，建立10 MBit/s的有效连接。RxTx指示灯亮起建立到相应以太网设备的链路。未发送/接收以太网包RxTx/黄色闪烁建立到相应以太网设备的链路。发送/接收以太网包。RxTx LED熄灭与相应以太网单元的链路未建立PRIM黄色LED，用于指示冗余配置中的主单元。DUAL黄色LED指示冗余配置。键入以太网单元。协议基金会现场总线高速以太网，TCP/IP。IEEE 802.3 100baseTX中定义的通信速度为10 Mbit/s/100 Mbit/s。状态指示灯正常运行：绿色。异常故障：红色。一个流量指示器-RxTx-由流量速度控制。连接器RJ45电流消耗（来自CEX总线24 V DC）100 mA典型值（150 mA）。功耗2.4 W典型值。根据EN60529和IEC 529，防护等级为IP20。
F(ault) /Red Unit error detected. Controlled by Control Software. Set and cleared by the hardware during controller Reset. R(un) /Green Operating. Controlled by the Control Software. Cleared by the hardware during controller Reset. 100MBit/s is ON A valid connection with100 MBit/s is established when Rx Tx/Yellow is flashing. 100MBit/s is OFF A valid connection with10 MBit/s is established when Rx Tx/Yellow is flashing. RxTx LED is ON A link to the corresponding Ethernet device is established. No Ethernet packages are sent/received RxTx/Yellow flashing A link to the corresponding Ethernet device is established. Ethernet packages are sent/received. RxTx LED is OFF A link with the corresponding Ethernet unit is not established PRIM A yellow LED for indicating the primary unit in redundant configuration. DUAL The yellow LED indicates the redundant configuration.Type Ethernet unit. Protocol FOUNDATION Fieldbus High Speed Ethernet, TCP/IP. Communication speed 10 Mbit/s / 100 Mbit/s defined in IEEE 802.3 100baseTX. Status indicators Running normally: Green. Exceptional fault: Red. One traffic indictor - RxTx - controlled by traffic pace. Connector RJ45 Current consumption (from CEX-Bus 24 V DC) 100 mA typical (150 mA max.). Power dissipation 2.4 W typical. Protection Rating IP20 according to EN60529, IEC 529.
2.产 品 展 示
3.公 司 优 势 主 营 产 品
4.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司，转载请附上此链接:
