厂家江苏南京专业（全国的的）起重机（电动葫芦、卷扬机、塔机、传输机、电机）无线遥控器产品
厂家江苏南京陈
起重机（电动葫芦、卷扬机、塔机、传输机、电机）无线遥控器（单速、双速--2路、4路、6路、8路、10路、12路、14路、16路、18路、20路、22路、24路、26路、28路、30路、42路、64路）
一、产品详细：
开关量（点动式、自保持）遥控器、模拟量遥控器、开关量模拟量混合式遥控器、RS232（RS485）通信遥控器、PLC连接遥控器、一控多遥控器、多控一遥控器、多控多遥控器、按键式遥控器、摇杆式遥控器、拨杆式遥控器、远程控制（如500米、1000米、3000米）遥控器、面板式遥控器、液晶显示屏遥控器、数据双向传输遥控器、单向传输控制遥控器等、单双速遥控器、多速遥控器等。
起重机（电动葫芦、卷扬机、塔机、传输机、电机）无线遥控器适用范围：卷扬机/升降机/电机正反转/电动葫芦/行车（天车）/吊车（行吊、龙门吊、码头吊、过轨吊、塔吊、汽车吊等）/起重机（门式起重机、龙门起重机、葫芦吊起重机、单双梁起重机）/矿井矿山轨道车/机车/数控设备/消防车/垃圾车/仓库自动化货架穿梭板小车/机器人小车等
二、产品特点:
•抗同频及非同频干扰
外壳及核心线路板均为工业级处理，核心处理器工速50kbps，GFSK调制调谐性能高效，可抵御任何无线信号及有线信号干扰，CRC纠错机制。多频道可选，瞬间调频，码分多址，安全码40亿组，同区多台相同时间点应用相互无任何影响，且与使用数量更多无关。
•无向信号传输
无线电波作为传输数据媒介，无方向性，可跨越各类障碍物，适用于任何复杂、恶劣、高温等工业应用环境。
•自检自保护线路
看门狗保护，且遥控系统每10秒自检一次，一旦系统故障，则瞬间关闭功能输出。
•电量欠压提示
2节5号电池可用1月左右，每小时自检一次电量状况，欠压则红灯亮提示，此时应及时更换电池，否则继续2小时自动关机。
•双向实时通讯
每套遥控系统均可双向控制，可两套或多套配合使用，发射端控制接收端，且两点间实时通信，信号传输机控制灵敏，瞬间响应，确保应用精确精准*，安全可靠！
•扩展如复杂型一发对多收控制、多发对多收控制、多发对一收控制等
同区同环境同一时间点一台发射机可分别或同时控制多个接收机同步或不同步工作。 同理，同区同环境多个发射机可同时或分别控制同一台接收机执行相应指令。发射机可配转换开关与有线切换应用，此开关也可不用，只要遥控接收机接线方式与原线控接线并联即可，有线与无线两种控制方式均可正常使用，两者可互为备用。多发一收同环境应用以抢答方式管理控制，先到先得，同一时间针对同一动作指令仅执行zui先发来的发射端指令。
三、起重机（电动葫芦、卷扬机、塔机、传输机、电机）无线遥控器参数
（1）发射器技术参数
标配： 定制
频率：422.4-473.6MHZ 可定做2.4GHZ
功率：10dBm 可定做2W、5W
遥距：100m 可定做500m、1000m、2000m、5000m
密保：40亿组
天线：内藏 可定做外引天线
防护等级：IP65
电源：3VDC（2节5号电池） 可定做外接电源DC24V
工温：-40°- +70°
面板：启动、急停、上（A）下（B）左（C）右（D）等依次类推 按键文字可定制
功能键: 如上（A）下（B）点动互锁。可定做自保持；不互锁（20、35路等）
按键：微动微调按键式开关 可定做外接引线
尺寸：168mm、 22mm、 44mm（长、宽、高）
重量:约半斤（含两节五号电池）
扩展通信：可PLC连接，液晶回传显示。
（2）接收机技术参数
标配： 定制
频率：422.4-473.6MHZ 可定做2.4GHZ
耗功：小于5W
接收灵敏：-100dBm
遥距：100m 可定做500m、1000m、2000m、5000m
密保：40亿组
天线：柱状 可定做延长或内置天线
防护：IP65
电源：AC380 AC220 AC36 可定做DC48V 24V 12V AC48V
工温：-40°- +70°
信号输出：无源开关量 可定做模拟量（电压、电流）
通道:n个 可定做多路如20个、35个、64个等
输出触点量值：250VAC 5A 3DVDC 5A
信号端：1.2米电缆+U状端子 可定做插头用于特殊接口
按键：微动微调按键式开关 可外接引线
尺寸：187mm、 125mm、 70mm（长、宽、高）
重量:约1公斤（带1.2米电缆）
扩展通信：RS232、RS485、CNN总线等。
四、起重机（电动葫芦、卷扬机、塔机、传输机、电机）无线遥控器整机标配：
•发射1支（内带2节电池）
•防水密封袋1个
•接收1部（10cm橡胶柱状天线）
•接收自带1.2米电缆
Jiangsu Nanjing professional manufacturers （ the country's best best ） crane （ hoist, winch, crane, transmission machine, motor ） wireless remote control products
Manufacturers of Jiangsu Nanjing Chen manager
Crane （ hoist, winch, crane, transmission machine, motor ） wireless controller （ single speed, double speed - 2 Road, 4 road, 6 road, 8 Road, 10 road, 12 road, 14 Road, 16 Road, 18 road, 20 road, 22 Road, 24 Road, 26 Road, 28 Road, 30 Road, 42 Road, 64 Road ）
One, product detail:
Switch （ point type, since maintaining ） remote control, remote control, analog switch analog mixed type remote controller, RS232 （ RS485 ） communication remote control, remote control, a PLC connected to multiple remote controller, a remote control, remote control, more control over key type remote control, rocker type remote controller, the deflector rod type remote controller, remote control （ such as 500 meters, 1000 meters, 3000 meters） remote control, remote control, LCD panel type remote controller, data transmission in remote control, one-way transmission control remote control, single and double speed controller, speed controller and so on.
Crane （ hoist, winch, crane, transmission machine, motor ） wireless remote control scope: windlass / Lift / motor / electric hoist crane （crane ） / / crane （ crane, gantry crane, wharf cranes, rail crane, tower crane, crane and so on ） / crane （ gantry crane, Longmen crane, hoist crane, single and double beam crane ） / mine rail car / motorcycle / NC equipment / fire / garbage truck / warehouse automation shelf shuttle plate trolley / robot etc.
Two, product characteristics:
De anti-same frequency and a same frequency interference
Shell and the core circuit board for industrial processing, the core processor working speed 50kbps, GFSK modulation tuning properties of high performance, can withstand any wireless signal and the wired signal interference, CRC error correction mechanism. Multi channel optional, flash FM, CDMA, safety code 4000000000, the area more than the same time point application together without any effect, and with the use of more independent.
" No to signal transmission
Radio wave data as the transmission medium, no direction, can span all kinds of obstacles, applicable to any complex, severe, high temperature and other industrial application environment.
Self test, protection circuit
Watchdog protects remote control system, and every 10 seconds a self-test, once the system failure, then close function output.
" Battery undervoltage tip
2 5 batteries available around January, every hour a self-test N condition, under-voltage, red light tip, at this time should be timely replacement of batteries, or to continue 2 hours of automation shut-down.
, bidirectional real-time communication
Each remote control system can control, but two or more with the use of a transmitting terminal control, receiving terminal, and two of the real-time communication, signal transmission machine sensitive control, transient response, to ensure that the application of precise accurate error free, absoluy safe and reliable!
As a complex type, extended to close more control, multiple to multiple receiving control, multiple on a charge control
The same district with the environment at the same time a transmitter can be respectively or simultaneously control a plurality of receiver synchronous or asynchronous. Similarly, the same district with the environment of multiple transmitters can simultaneously or respectively control with a receiver to perform a corresponding instruction. The transmitter can be equipped with the switch and cable switching applications, the switch can not, as long as the remote control receiver wiring mode and the original wire connection parallel combinations, wired and wireless two control modes can be normal use, both of which can be mutually spare. Multiple applications to answer a charge with the environment management control, first come first served, the same time for the same action instructions perform only the first sent to the transmitting end instruction.
In three, crane （ hoist, winch, crane, transmission machine, motor ） wireless remote control parameters
（ 1） the transmitter technology parameters
Standard: Custom
Frequency: 422.4-473.6MHZ can be customized 2.4GHZ
Power: 10dBm 2W, 5W can be customized
Distance: 100M can be customized 500m, 1000m, 2000m, 5000m
Security: 4000000000 groups
Antenna: inside can be customized with antenna
Protection grade: IP65
Power: 3VDC （ 2 No. 5 battery ） can be customized external power supply DC24V
Working temperature: - 40 degrees to + 70 degrees
Panel: start, stop, on （ A ） （ B ） under the left （ C ） right （ D ）, followed by analogy key words can be customized
Key: as （ A ） （ B ） under dynamic interlocking. Can be customized by; not interlock （ 20, 35 Road ）
Keys: micro tuning button switch can be customized external connection wire
Size: 168mm, 22mm, 44mm （ length, width, height）
Weight: about half a catty （including two No. five batteries ）
Extended communication: PLC connection, LCD back display.
（ 2） receiver technology parameters
Standard: Custom
Frequency: 422.4-473.6MHZ can be customized 2.4GHZ
Power consumption : less than 5W
Receiving sensitivity: - 100dBm
Distance: 100M can be customized 500m, 1000m, 2000m, 5000m
Security: 4000000000 groups
Antenna : column can be customized to extend or built-in antenna
Protection: IP65
Source: AC380 AC220 AC36 DC48V 24V 12V AC48V can be customized
Working temperature: - 40 degrees to + 70 degrees
Signal output: passive switch can be custom-made analog （ voltage, current）
Channel: n can be customized multiple such as 20, 35, 64 etc.
Output contact value: 250VAC 5A 3DVDC 5A
Signal end: 1.2 meter cable + U shaped terminal can be customized for specific interface plug
Keys: micro tuning button switch can be connected with the lead wire
Size: 187mm, 125mm, 70mm （ length, width, height）
Weight: about 1 kg （with 1.2 meter cable ）
Extended communication: RS232, RS485, CNN bus.
In four, crane （ hoist, winch, crane, transmission machine, motor ） wireless remote machine standard:
, 1 （ launched with 2 batteries）
Waterproof sealing bag, 1
, receiving 1 （ 10cm rubber column antenna ）
Receiving, with 1.2 meter cable
